The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
Refer to Brake Warning Light Remains ON (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>Brake Warning Light Remains ON).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check if CAN communication system DTCs are output (See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Check that the brake warning light comes on.
| Proceed to |
|---|
| NG |
| OK |
Reconnect the skid control ECU connector.
OK
NG
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Brake Warning Light | Brake warning light / OFF or ON | OFF | - |
When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Brake Warning Light | Brake warning light | Warning light ON/OFF | Observe the combination meter. |
| Result | Proceed to | |
|---|---|---|
| Data List Display | Data List Display when Performing Active Test ON/OFF Operation | |
| ON | Changes between ON and OFF | A |
| Does not change between ON and OFF | B | |
| OFF | Changes between ON and OFF | A |
| Does not change between ON and OFF | B | |
Disconnect the GTS from the DLC3.
A
B