The power steering ECU assembly outputs this DTC when it determines that the assist map is not written in the ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1581 | Assist map not written in power steering ECU assembly | ·
Power steering ECU assembly ·
CAN communication system ·
ECM |
If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
NEXT
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
DTC C1581 is not output.
DTC C1581 will be cleared after the assist map is written.
OK
NG
Check for DTCs of the CAN communication system.
w/o Toyota Safety Sense: (See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>DIAGNOSIS SYSTEM)
w/ Toyota Safety Sense: (See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/ Toyota Safety Sense)>DIAGNOSIS SYSTEM)
| Result | Proceed to |
|---|---|
| DTCs is not output | A |
| DTCs is output (w/o Toyota Safety Sense) | B |
| DTCs is output (w/ Toyota Safety Sense) | C |
A
B
C
Check if an ECM that complies with the vehicle specifications is installed.
The ECM that complies with vehicle specifications is installed.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1NZ-FE) | B |
| NG (for 2NZ-FE) | C |
A
B
C