Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2017.01
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1582  Assist Map Number Mismatch  


DESCRIPTION

When an incorrect ECM is installed after the assist map has been recorded in the power steering ECU assembly, then DTC C1582 is stored because the data does not match the vehicle specifications.

DTC No. DTC Detection Condition Trouble Area
C1582 Assist map number mismatch
·

Power steering ECU assembly

·

CAN communication system

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check for DTCs of the CAN communication system.

w/o Toyota Safety Sense: (See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>DIAGNOSIS SYSTEM)

w/ Toyota Safety Sense: (See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/ Toyota Safety Sense)>DIAGNOSIS SYSTEM)

Result
Result Proceed to
DTCs is not output A
DTCs is output (w/o Toyota Safety Sense) B
DTCs is output (w/ Toyota Safety Sense) C



A

2.CHECK ECM

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

C

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK ECM
a.

Check if an ECM that complies with the vehicle specifications is installed.

OK:

The ECM that complies with vehicle specifications is installed.


Result
Result Proceed to
OK A
NG (for 1NZ-FE) B
NG (for 2NZ-FE) C



A

REPLACE POWER STEERING ECU ASSEMBLY

B

C