The main body ECU (multiplex network body ECU) determines the status of the automatic high beam system based on the automatic high beam system signal from the pre-crash safety city sensor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B124B | Automatic high beam system malfunction | ·
Pre-crash safety system ·
Lane departure alert system ·
SFI system ·
Vehicle stability control system ·
CAN communication system ·
Pre-crash safety city sensor ·
Main body ECU (multiplex network body ECU) |
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.
Click here Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/ Toyota Safety Sense)>DIAGNOSIS SYSTEM
This DTC is output simultaneously from the pre-crash safety city sensor when DTCs related to the items below are output.
Wheel speed sensor malfunction
Yaw rate sensor malfunction
Steering sensor malfunction
CAN communication lost
Connect the GTS to the DLC3.
Turn the ignition switch ON.
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B124B is output | A |
| DTC B124B is output at the same time | B |
A
B
Check that no pre-crash safety system warnings are displayed.
No pre-crash safety system warnings.
OK
NG