Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2017.01–2018.06
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0307822 PRE-CRASH SAFETY SYSTEM T

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

When replacing the combination meter assembly, make sure to replace it with a new one.

·

When replacing the pre-crash safety city sensor, replace it with a new one and be sure to initialize the settings. If an ECU which was installed to another vehicle is used, the information stored in the pre-crash safety city sensor will not match the information from the vehicle and, as a result, a DTC may be output.



HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.

Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Pre-crash Safety System
Symptom Suspected Area See page
PCS warning light (PCS OFF indicator) is blinking. The pre-crash safety city sensor temperature is extremely high and the system will not operate. When the temperature return to normal, normal control will return (Check High or Low Temperature Status). (Click here)
The pre-crash safety city sensor cannot detect obstacles due to dirt. When dirt is removed, normal control will return (Check Lidar Blockage Status). (Click here)
The pre-crash safety system does not operate due to abnormal pre-crash safety city sensor voltage (Click here)
Pre-crash safety city sensor (Click here)
Combination meter assembly (Click here)
Although there is possibility of collision, pre-crash safety control (all front collision controls) does not operate. (when PCS warning light [PCS OFF indicator] does not illuminate) Vehicle condition/environment does not match pre-crash safety control operation conditions. (Confirm control operation conditions) (Click here)
Data List (PCS Operation State Retention Setting) (Click here)
Laser Sensor Inspection (Click here)
Pre-crash safety system circuit (Click here)
Check pre-crash safety city sensor installation condition (Click here)
Adjust pre-crash safety city sensor beam axis
·

Perform adjustment using "ONE TIME RECOGNITION" or "SEQUENTIAL RECOGNITION".

·

ONE TIME RECOGNITION

(Click here)

·

SEQUENTIAL RECOGNITION

(Click here)


Pre-crash safety city sensor (Click here)
Combination meter assembly (Click here)
Although there is no possibility of collision, pre-crash safety control (all front collision controls) operates. Driving condition/environment matches pre-crash safety control operation conditions. (Check precaution for pre-crash safety city sensor) (Click here)
Laser Sensor Inspection (Click here)
Check pre-crash safety city sensor installation condition (Click here)
Adjust pre-crash safety city sensor beam axis
·

Perform adjustment using "ONE TIME RECOGNITION" or "SEQUENTIAL RECOGNITION".

·

ONE TIME RECOGNITION

(Click here)

·

SEQUENTIAL RECOGNITION

(Click here)


Pre-crash safety city sensor (Click here)
Pre-crash safety system cannot be canceled (PCS warning light [PCS OFF indicator] does not illuminate) Check pre-crash safety system cancel switch assembly condition (Click here)
Data List (PCS Operation State Retention Setting) (Click here)
Pre-crash safety system switch circuit (Click here)
Pre-crash safety city sensor (Click here)
Combination meter assembly (Click here)
Pre-crash brake and pre-crash brake assist cannot be canceled (PCS warning light [PCS OFF indicator] does not illuminate) Check VSC OFF switch condition (Click here)
Data List (PCS Operation State Retention Setting) (Click here)
Vehicle stability control system (Click here)
Pre-crash safety city sensor (Click here)
Combination meter assembly (Click here)
Pre-crash safety system warning timing cannot be changed (LCD display sensitivity setting screen does not display) Check pre-crash safety system cancel switch assembly condition (Click here)
Pre-crash safety system switch circuit (Click here)
Pre-crash safety city sensor (Click here)
Combination meter assembly (Click here)