Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY › from 2017.01
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248416 HEADLIGHT ASSEMBLY A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE FRONT BUMPER ASSEMBLY

Hide 81150 4.REMOVE HEADLIGHT ASSEMBLY

a.
E366190

Apply protective tape around the headlight assembly as shown in the illustration.


b.
E366191

Remove the 3 screws.


c.

Disconnect the connectors to remove the headlight assembly.