Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
81150
1.INSTALL HEADLIGHT ASSEMBLY
Connect the connectors.
Install the headlight assembly with the 3 screws.
Remove the protective tape.
2.INSTALL FRONT BUMPER ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.ADJUST HEADLIGHT AIMING
5.ADJUST FOG LIGHT AIMING (w/ Fog Light)