Anti-lock Brake System
Symptom
| Suspected Area
| See page
|
ABS and/or EBD does not operate
| Check for DTCs again and make sure that the normal system code is output.
|
Click here
|
IG power source circuit (low power supply voltage malfunction)
|
Click here
|
IG power source circuit (high power supply voltage malfunction)
|
Click here
|
Front speed sensor circuit (comparison malfunction)
|
Click here
|
Front speed sensor circuit (open or short malfunction)
|
Click here
|
Front speed sensor circuit (output malfunction)
|
Click here
|
Rear speed sensor circuit (comparison malfunction)
|
Click here
|
Rear speed sensor circuit (open or short malfunction)
|
Click here
|
Rear speed sensor circuit (output malfunction)
|
Click here
|
Check the skid control ECU (brake actuator assembly) with the Techstream. (Check skid control ECU (brake actuator assembly) operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks.
|
Click here
|
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly).
|
Click here
|
ABS and/or EBD does not operate efficiently
| Check for DTCs again and make sure that the normal system code is output.
|
Click here
|
Front speed sensor circuit (comparison malfunction)
|
Click here
|
Front speed sensor circuit (open or short malfunction)
|
Click here
|
Front speed sensor circuit (output malfunction)
|
Click here
|
Rear speed sensor circuit (comparison malfunction)
|
Click here
|
Rear speed sensor circuit (open or short malfunction)
|
Click here
|
Rear speed sensor circuit (output malfunction)
|
Click here
|
Stop light switch circuit
|
Click here
|
Check the skid control ECU (brake actuator assembly) with the Techstream. (Check skid control ECU (brake actuator assembly) operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks.
|
Click here
|
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly).
|
Click here
|
ABS sensor DTC check cannot be done
| Check for DTCs again and make sure that the normal system code is output.
|
Click here
|
TC and CG terminal circuit
|
Click here
|
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly).
|
Click here
|
ABS warning light abnormal (Remains on)
| ABS warning light circuit
|
Click here
|
Skid control ECU (brake actuator assembly)
|
Click here
|
ABS warning light abnormal (Does not come on)
| ABS warning light circuit
|
Click here
|
Skid control ECU (brake actuator assembly)
|
Click here
|
Brake warning light abnormal (Remains on)
| Brake warning light circuit
|
Click here
|
Skid control ECU (brake actuator assembly)
|
Click here
|
Brake warning light abnormal (Does not come on)
| Brake warning light circuit
|
Click here
|
Skid control ECU (brake actuator assembly)
|
Click here
|
Sensor check cannot be done
| TS and CG terminal circuit
|
Click here
|
Skid control ECU (brake actuator assembly)
|
Click here
|