DTC C1203 ECM Communication Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1203 | Engine, drive source and destination variations that are sent from the ECM or main body ECU (multiplex network body ECU) do not match the ones of the skid control ECU (brake actuator assembly). |
|
| 1.CHECK PART NUMBER (ECM AND BRAKE ACTUATOR ASSEMBLY) |
Check that the proper ECM is installed.
| Result | Proceed to |
| Proper ECM is installed | A |
| Proper ECM are not installed | B |
|
| ||||
| A | |
| 2.CHECK PART NUMBER (MAIN BODY ECU AND BRAKE ACTUATOR ASSEMBLY) |
Check that the proper main body ECU (multiplex network body ECU) is installed.
| Result | Proceed to | |
| Proper ECU is installed | A | |
| Proper ECU is not installed | B | |
|
| ||||
| A | |
| 3.CHECK BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) |
Check if the skid control ECU (brake actuator assembly) had been replaced before the DTC was recorded.
| Result | Proceed to |
| The brake actuator assembly is not replaced | A |
| The brake actuator assembly is replaced | B |
|
| ||||
| A | |
| 4.RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||
| 5.PERFORM TEST MODE PROCEDURE |
Perform test mode procedure (Click here).
| NEXT | |
| 6.RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||