DTC C1434 Steering Angle Sensor Output Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1434 | Normal communication between the skid control ECU and the steering angle sensor and abnormal steering angle sensor zero point. |
|
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON again and check that no CAN communication system DTC is output (Click here).
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) and check that no speed sensor or yaw rate and acceleration sensor DTCs are output (Click here).
| Result | Proceed to |
| No CAN communication system, speed sensor, or yaw rate and acceleration sensor DTCs are output | A |
| CAN communication system DTC is output | B |
| Speed sensor or yaw rate and acceleration sensor DTC is output | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK TERMINAL VOLTAGE (BAT TERMINAL) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D122-6 (BAT) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | |
| 3.CHECK TERMINAL VOLTAGE (IG TERMINAL) |
![]() |
Remove the steering wheel and the column cover lower.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the steering angle sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D122-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (ESS TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D122-2 (ESS) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Steering angle sensor) |
Reconnect the steering angle sensor connector.
Reinstall the steering wheel and the column cover lower.
|
| ||||
| OK | ||
| ||