ANTI-LOCK BRAKE SYSTEM (for Sedan) > ABS Warning Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK ABS WARNING LIGHT |
Disconnect the A15 brake actuator assembly (skid control ECU) connector.
Turn the ignition switch to ON.
Check that the ABS warning light comes on.
Reconnect the A15 brake actuator assembly (skid control ECU) connector.
|
| ||||
| OK | ||
| ||
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (Indicat. Lamp ABS) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp ABS | ABS warning light | OFF/ON | Perform the test with the vehicle stopped and the engine idling |
Check that the ABS warning light on the combination meter turns on or off in accordance with the tester operation.
|
| ||||
| OK | ||
| ||