AIRBAG SYSTEM (for Hatchback with VSC) > SRS Warning Light Remains ON |

| 1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM) |
Turn the ignition switch to ON.
Check the DTCs (Click here).
|
| ||||
| OK | |
| 2.INSPECT BATTERY |
Measure the voltage of the battery.
| Tester Connection | Condition | Specified Condition |
| Battery | Always | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK CONNECTION OF CONNECTORS |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Check that the connectors are properly connected to the airbag sensor assembly and combination meter assembly.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF AIRBAG SENSOR ASSEMBLY) |
![]() |
Disconnect the connectors from the airbag sensor assembly.
Connect the cable to the negative battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON.
Operate all components of the electrical system (defogger, wipers, headlights, heater blower, etc.).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D112-21 (IG2) - D112-25 (E1) | Ignition switch ON | 11 to 14 V |
| D112-21 (IG2) - D112-26 (E2) | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER ASSEMBLY) |
![]() |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the connector from the combination meter assembly.
Connect the cable to the negative battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D100-39 (IG+) - D100-21 (ET) | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | |
| 6.CHECK SRS WARNING LIGHT |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Connect the connector to the combination meter assembly.
Connect the cable to the negative battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON.
Check the SRS warning light condition.
|
| ||||
| OK | ||
| ||