DTC C1437 Lost Communication with ECM |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1437 | When the IG1 terminal voltage is 10 V or more and the vehicle speed is 15 km/h (9 mph) or more, data cannot be sent to the ECM for 2 seconds or more. |
|
| 1.CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION) |
Using the Techstream, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| EFI Communication Open | EFI communication open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC C1437 is not output | A |
| DTC C1437 is output | B |
| CAN communication system DTC is output | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.REPAIR OR REPLACE HARNESS OR CONNECTOR (SKID CONTROL ECU - ECM) |
Turn the ignition switch off.
Repair or replace the harness or connector.
Check for any momentary interruption between the skid control ECU (brake actuator assembly) and the ECM (Click here).
Check that there is no momentary interruption.
| NEXT | |
| 4.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC C1437 is not output | A |
| DTC C1437 is output | B |
| CAN communication system DTC is output | C |
|
| ||||
|
| ||||
| A | ||
| ||