Home › General › INTRODUCTION › REPAIR INSTRUCTION (for Sedan)

REPAIR INSTRUCTION (for Sedan) > INITIALIZATION



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

Procedures Necessary when ECU or Other Parts are Replaced 
Replacement Part
Necessary Procedures
Effect / Inoperative Function when Necessary Procedures are not Performed
See page
ECM
ECU communication ID registration
(Engine immobiliser system)
Engine starting
Click here
  1. ECM, Throttle with motor body assembly or any throttle body components
  2. Throttle body is cleaned
Initialization
-
Click here
Automatic transaxle assembly, engine assembly or ECM
  1. Road test
  2. Reset memory
Large shift shock
Click here
  1. Power steering ECU
  2. Power steering column assembly
  3. Steering wheel
  4. Steering gear assembly
Perform rotation angle sensor initialization and torque sensor zero point calibration
  1. Power steering warning light comes on
  2. EPS control
Click here
  1. Door control receiver
  2. Key
Code registration
Wireless door lock control system
Click here
  1. Transponder key ECU
  2. Key
ECU communication ID registration
(Engine immobiliser system)
Engine starting
Click here
  1. Occupant classification ECU
  2. Accessories (seatback tray and seat cover, etc.) are installed
  3. Front passenger seat is removed from the vehicle
  4. Vehicle is brought to the workshop for repair due to an accident or a collision
  1. Perform zero point calibration
  2. Sensitivity check
  1. Occupant classification system
  2. Airbag system (Front passenger side)
  3. Seat belt warning system (Front passenger side)
Click here