Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (for Sedan)

DTC    B279A    Theft Deterrent System Communication Line High Fixation


DESCRIPTION

If the communication line (EFIO-IMI) to the transponder key ECU is stuck on HI output, the ECM outputs this DTC.

DTC No.
DTC Detection Condition
Trouble Area
B279A
Communication line (EFIO-IMI) between ECM and the transponder key ECU is stuck on HI output
  1. Wire harness
  2. Transponder key ECU
  3. ECM

WIRING DIAGRAM


B195604E08


INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, register the key and ECU communication ID (Click here).
  2. If the ECM is replaced, register the ECU communication ID (Click here).

1.CHECK DTC OUTPUT
  1. Recheck for DTCs (Click here).

    HINT:
    If any DTCs other than DTC B279A are output, troubleshoot those DTCs first.

    Result:
    Result
    Proceed to
    DTC B279A and other DTCs reoutput
    A
    DTC B279A reoutput
    B



A
GO TO DTC CHART (Click here)
B


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
  1. Disconnect the D23 transponder key ECU connector.



  1. Disconnect the A21 ECM connector.


    B164262E25

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D23-13 (EFIO) - A21-11 (IMI)
    Always
    Below 1 Ω
    D23-13 (EFIO) - Body ground
    Always
    10 kΩ or higher

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D23-13 (EFIO) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.PERFORM ACTIVE TEST USING ECM (INPUT)
  1. Reconnect the transponder key ECU assembly connector.

  1. Reconnect the ECM connector.



  1. Measure the waveform.


    B193462E04

    Waveform 1 (Reference):
    Item
    Content
    Terminal No. (Symbols)
    A21-11 (IMI) - C20-104 (E1)
    Tool Setting
    2 V/DIV., 1 s./DIV.
    Condition
    Ignition switch ON

    OK:
    Normal waveform is output



NG
REPLACE ECM (Click here)
OK


4.REPLACE TRANSPONDER KEY ECU
  1. Replace the transponder key ECU assembly (Click here).


NEXT


5.REGISTER KEY
  1. Register the key (Click here).


NEXT


6.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Click here).


NEXT


7.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B279A is not reoutput.



NG
REPLACE ECM (Click here)
OK

END (TRANSPONDER KEY ECU IS DEFECTIVE)