DTC C1436 Yaw Rate Sensor Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1436 | Either of the following is detected:
| Yaw rate and deceleration sensor (Airbag sensor assembly) |
| 1.READ VALUE USING TECHSTREAM (YAW RATE SENSOR) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Yaw Rate Sensor | Yaw rate sensor/min.: -128°/s, max.: 127°/s | 0°/s: Vehicle stationary -128 to 0°/s: Turning right 0 to 127°/s: Turning left | - |
Check that the yaw rate and deceleration sensor (airbag sensor assembly) output value displayed on the Techstream.
| Result | Proceed to |
| NG (The yaw rate and deceleration sensor (airbag sensor assembly) output value is 0°/s when the vehicle is stationary, but the value fluctuates when turning) | A |
| NG (The yaw rate and deceleration sensor (airbag sensor assembly) output value is not 0°/s when the vehicle is stationary) | B |
| OK | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK YAW RATE AND DECELERATION SENSOR (AIRBAG SENSOR ASSEMBLY) INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and deceleration sensor (airbag sensor assembly) has been installed properly (Click here).
|
| ||||
| OK | ||
| ||