DTC B1423 Pressure Sensor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1423 | Either condition is met:
|
|

| 1.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Disconnect the A60 air conditioner pressure sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A60-3 (+) - Body ground | Ignition switch ON | 4.75 to 5.25 V |
| *a | Front view of wire harness connector (to Air Conditioner Pressure Sensor) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GROUND CIRCUIT) |
![]() |
Disconnect the A60 air conditioner pressure sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A60-1 (-) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Air Conditioner Pressure Sensor) |
|
| ||||
| OK | |
| 3.CHECK AIR CONDITIONER PRESSURE SENSOR (SENSOR SIGNAL CIRCUIT) |
Reconnect the air conditioner pressure sensor connector.
![]() |
Remove the air conditioning amplifier assembly with its connectors still connected (Click here).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D130-7 (PRE) - Body ground | Ignition switch ON A/C switch off | 0.63 to 4.73 V |
| *a | Component with harness connected (Air Conditioning Amplifier Assembly) |
|
| ||||
| OK | |
| 4.CHECK AIR CONDITIONER PRESSURE SENSOR (SENSOR SIGNAL CIRCUIT) |
![]() |
Measure the voltage when the following conditions are met.
| Item | Condition |
| Engine Speed | 1500 rpm |
| Vehicle Doors | Fully open |
| Temperature Setting | MAX COOL |
| Blower Speed | HI |
| A/C Switch | ON |
| R/F Switch | Recirculation |
| Interior Temperature | 25 to 35°C (77 to 95°F) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D130-7 (PRE) - Body ground | Ignition switch ON A/C switch on | 0.63 to 4.73 V |
| *a | Component with harness connected (Air Conditioning Amplifier Assembly) |
| Result | Proceed to |
| OK (When troubleshooting according to the DTC) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (AIR CONDITIONER PRESSURE SENSOR - AIR CONDITIONING AMPLIFIER ASSEMBLY) |
Disconnect the A60 air conditioner pressure sensor connector.
Disconnect the D130 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A60-3 (+) - D130-24 (S5- 3) | Always | Below 1 Ω |
| A60-3 (+) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 6.CHECK HARNESS AND CONNECTOR (AIR CONDITIONER PRESSURE SENSOR - AIR CONDITIONING AMPLIFIER ASSEMBLY) |
Disconnect the A60 air conditioner pressure sensor connector.
Disconnect the D130 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A60-1 (-) - D130-5 (SG-2) | Always | Below 1 Ω |
| A60-1 (-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 7.CHECK HARNESS AND CONNECTOR (AIR CONDITIONER PRESSURE SENSOR - AIR CONDITIONING AMPLIFIER ASSEMBLY) |
Disconnect the A60 air conditioner pressure sensor connector.
Disconnect the D130 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A60-2 (PR) - D130-7 (PRE) | Always | Below 1 Ω |
| A60-2 (PR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 8.CHECK FOR AIR CONDITIONING SYSTEM LEAK |
Install a manifold gauge set.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
Evacuate the air conditioning system and check that vacuum can be maintained in it.
|
| ||||
| OK | |
| 9.CHARGE REFRIGERANT |
Add an appropriate amount of refrigerant (Click here).
| NEXT | |
| 10.CHECK FOR DTC |
Check for DTCs when the following conditions are met (Click here).
| Item | Condition |
| Engine Speed | 1500 rpm |
| Vehicle Doors | Fully open |
| Temperature Setting | MAX COOL |
| Blower Speed | HI |
| A/C Switch | ON |
| R/F Switch | Recirculation |
| Interior Temperature | 25 to 35°C (77 to 95°F) |
|
| ||||
| OK | ||
| ||
| 11.INSPECT AIR CONDITIONER PRESSURE SENSOR |
Inspect the air conditioner pressure sensor (Click here).
|
| ||||
| OK | ||
| ||
| 12.REPAIR AIR CONDITIONING SYSTEM LEAK |
Identify the area where refrigerant leaks (Click here).
Repair the identified area of the air conditioning system.
Evacuate the air conditioning system.
| NEXT | ||
| ||
| 13.CHECK COOLING FAN SYSTEM |
Check that the cooling fan(s) operates normally.
|
| ||||
| OK | |
| 14.CHARGE REFRIGERANT |
Use a refrigerant recovery unit to recover refrigerant.
Evacuate the air conditioning system.
Add an appropriate amount of refrigerant (Click here).
| NEXT | |
| 15.CHECK FOR DTC |
Check for DTCs when the following conditions are met (Click here).
| Item | Condition |
| Engine Speed | 1500 rpm |
| Vehicle Doors | Fully open |
| Temperature Setting | MAX COOL |
| Blower Speed | HI |
| A/C Switch | ON |
| R/F Switch | Recirculation |
| Interior Temperature | 25 to 35°C (77 to 95°F) |
|
| ||||
| OK | |
| 16.REPLACE COOLER EXPANSION VALVE |
Replace the cooler expansion valve with a new or normally functioning one (Click here).
| NEXT | |
| 17.CHARGE REFRIGERANT |
Add an appropriate amount of refrigerant (Click here).
| NEXT | |
| 18.CHECK FOR DTC |
Check for DTCs when the following conditions are met (Click here).
| Item | Condition |
| Engine Speed | 1500 rpm |
| Vehicle Doors | Fully open |
| Temperature Setting | MAX COOL |
| Blower Speed | HI |
| A/C Switch | ON |
| R/F Switch | Recirculation |
| Interior Temperature | 25 to 35°C (77 to 95°F) |
|
| ||||
| OK | ||
| ||
| 19.REPLACE AIR CONDITIONER PRESSURE SENSOR |
Replace the air conditioner pressure sensor (Click here).
| NEXT | |
| 20.CHECK FOR DTC |
Check for DTCs when the following conditions are met (Click here).
| Item | Condition |
| Engine Speed | 1500 rpm |
| Vehicle Doors | Fully open |
| Temperature Setting | MAX COOL |
| Blower Speed | HI |
| A/C Switch | ON |
| R/F Switch | Recirculation |
| Interior Temperature | 25 to 35°C (77 to 95°F) |
|
| ||||
| OK | ||
| ||