PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
Throttle body with motor assembly
ECM
Engine starting
Idling
for 1NZ-FE Engine, Automatic Transaxle
()
for 1NZ-FE Engine, Manual Transaxle
for 2NZ-FE Engine, Automatic Transaxle
for 2NZ-FE Engine, Manual Transaxle
Automatic transaxle assembly
Engine assembly
Road test
Reset memory
for U340E Automatic Transaxle
for U441E Automatic Transaxle
Power steering motor assembly
Power steering ECU assembly
Electric power steering column sub-assembly (containing the torque sensor)
EPS warning light comes on
EPS control
Transponder key ECU assembly*1
Key*1
Certification ECU (smart key ECU assembly)*2
Steering lock ECU (steering lock actuator assembly)*2
Electrical key transmitter sub-assembly*2
Wireless door lock control system
Smart Entry and Smart System
Engine start
Steering lock system
Door control transmitter assembly*1
Door control receiver*1
Front door window regulator assembly LH
Front power window regulator motor assembly LH
Door glass
Door glass run
Auto up and down function
Jam protection function
*1: w/o Smart Entry and Start System
*2: w/ Smart Entry and Start System