Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE DOOR LOCK CONTROL CABLE ASSEMBLY(for RHD) › 2013.08–2017.10
RM30M0E _59 Vehicle Exterior _017122 DOOR / HATCH _0087464 LUGGAGE DOOR LOCK CONTROL CABLE ASSEMBLY(for RHD) A

DOOR / HATCH  LUGGAGE DOOR LOCK CONTROL CABLE ASSEMBLY(for RHD)  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)

Hide 2.REMOVE REAR SEAT ASSEMBLY (for Separate Seat Type)

Hide 62111C 3.REMOVE COWL SIDE TRIM BOARD RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Sedan)>REMOVAL


Hide 62311B 4.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Sedan)>REMOVAL


Hide 62331A 5.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Sedan)>REMOVAL


Hide 73210 6.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL


Hide 62413A 7.REMOVE CENTER PILLAR LOWER GARNISH RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Sedan)>REMOVAL


Hide 62551F 8.REMOVE REAR SEAT SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Sedan)>REMOVAL


Hide 64719A 9.REMOVE LUGGAGE COMPARTMENT DOOR COVER

Hide 64772C 12.REMOVE SPARE WHEEL COVER PAD

a.
B345125

Remove the spare wheel cover pad.


Hide 64721B 14.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER

a.
B345127

Using a clip remover, remove the 4 clips and the No. 1 luggage compartment trim cover.


Hide 77306 15.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY

Hide 58510D 16.SEPARATE FRONT FLOOR CARPET ASSEMBLY

a.
B344846

Disengage the 5 guides and peel back the front floor carpet assembly from the driver side front floor.


b.
B344847

Disengage the 2 guides and peel back the front floor carpet assembly from the right side of the driver side rear floor.


Hide 64607 17.REMOVE LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY

a.
B345145

Disengage the 2 claws and open the cover in the direction indicated by the arrow as shown in the illustration.


b.
B345147

Disengage the guide and disconnect the luggage door lock control cable sub-assembly from the luggage door lock assembly.


c.

Remove the luggage door lock control cable sub-assembly from the 11 clamps as shown in the illustration.

B356967C01
0.896,1.979 1,1.885 false 1.938,1.292 2.104,1.135 false 5.906,0.865 5.927,0.656 true 3.563,0.427 3.708,0.271 true 1.833,1.042 2.01,1.094 true 1.302,1.781 1.396,1.667 true 0.823,2.906 0.885,2.833 false 0.646,2.719 0.729,2.635 true 1.938,5.406 2.052,5.448 false 2.021,5.125 2.094,5.333 true 3.281,0.667 3.385,0.531 false 6.615,1.656 6.542,1.49 false 6.302,1.656 6.458,1.51 true 4.844,0.604 4.823,0.385 true 4.948,0.813 4.833,0.688 false 5.906,0.573 5.979,0.396 false 3.729,3.188 3.771,2.917 true 3.667,3.469 3.677,3.281 false 1.854,4.979 2.167,5.177 0.313,0.198 10 false *1 1.75,5.302 2.063,5.5 0.313,0.198 10 false *2 0.708,2.531 1.021,2.729 0.313,0.198 10 false *1 0.875,2.729 1.188,2.927 0.313,0.198 10 false *2 1.354,1.563 1.667,1.76 0.313,0.198 10 false *1 0.823,1.99 1.135,2.188 0.313,0.198 10 false *2 4.896,0.813 5.208,1.01 0.313,0.198 10 false *2 1.677,0.958 1.99,1.156 0.313,0.198 10 false *1 3.208,0.667 3.521,0.865 0.313,0.198 10 false *2 6.208,1.677 6.521,1.875 0.313,0.198 10 false *1 1.854,1.302 2.167,1.5 0.313,0.198 10 false *2 3.688,0.156 4,0.354 0.313,0.198 10 false *1 5.844,0.885 6.156,1.083 0.313,0.198 10 false *1 5.969,0.292 6.281,0.49 0.313,0.198 10 false *2 4.771,0.24 5.083,0.438 0.313,0.198 10 false *1 6.604,1.677 6.917,1.875 0.313,0.198 10 false *2 3.74,2.792 4.052,2.99 0.313,0.198 10 false *1 3.615,3.479 3.927,3.677 0.313,0.198 10 false *2
*1 Luggage Door Lock Control Cable Sub-assembly *2 Clamp