Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT BLOWER MOTOR › 2013.08–2014.03
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0090061 FRONT BLOWER MOTOR A

HEATING / AIR CONDITIONING  FRONT BLOWER MOTOR  REMOVAL  


PROCEDURE

Hide 55412D 1.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL (w/ Radio Receiver)

Hide 55412D 2.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

Hide 3.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)

Hide 4.REMOVE RADIO TUNER OPENING COVER WITH BRACKET (w/o Radio Receiver)

Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55432B 6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for LHD)

Hide 55432B 7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for RHD)

Hide 55411G 8.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 9.REMOVE UPPER CENTER INSTRUMENT CLUSTER FINISH PANEL

Hide 55474C 10.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55650 11.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

Hide 55650 12.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)

Hide 55410C 13.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55550 14.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55900 15.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

Hide 55902C 16.REMOVE AIR CONDITIONING PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)

Hide 55604B 17.REMOVE INSTRUMENT PANEL CUP HOLDER SUB-ASSEMBLY

Hide 55475A 18.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55434B 20.REMOVE NO. 2 LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for LHD)

Hide 55434B 21.REMOVE NO. 2 LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for RHD)

Hide 55306A 22.REMOVE NO.1 INSTRUMENT PANEL BRACE SUB-ASSEMBLY

a.
I110523

Disengage the front floor cappet assembly, as shown in the illustration.


b.

Remove the clip and peel back the front floor carpet assembly.


c.
I110521

Disengage the 3 clamps.


d.

Remove the bolt, nut and 2 screws.


e.

Remove the No. 1 instrument panel brace sub-assembly.


Hide 87103B 23.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY

I110522

a.

Disconnect the connector.


b.

Remove the 3 screws and blower motor with fan sub-assembly.

NOTICE:

Do not apply excessive force to the instrument panel wire.