Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
43502C
1.INSTALL FRONT AXLE HUB SUB-ASSEMBLY
| *a | Matchmark |
Align the matchmarks on the front drive shaft assembly and front axle hub sub-assembly.
Be careful not to damage the thread portion of the front drive shaft assembly.
Install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 3 bolts.
Be careful not to damage the drive shaft boot.
43512
2.INSTALL FRONT DISC
3.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
43502H
4.TEMPORARILY INSTALL FRONT AXLE SHAFT NUT
Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using non-residue solvent.
Be sure to perform this work even when using a new front drive shaft assembly.
Keep the threaded parts free of oil and foreign matter.
Using a 30 mm socket wrench, while applying the brakes, temporarily install the front axle shaft nut.
Stake the front axle shaft nut after inspecting for looseness and runout in the following steps.
Keep depressing the brake pedal to prevent the front drive shaft assembly from rotating.
5.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
43512
6.REMOVE FRONT DISC
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
7.INSPECT FRONT AXLE HUB BEARING LOOSENESS
8.INSPECT FRONT AXLE HUB RUNOUT
43512
9.INSTALL FRONT DISC
10.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
43502H
11.INSTALL FRONT AXLE SHAFT NUT
Using a chisel and hammer, stake the front axle shaft nut.
47313A
12.INSTALL FRONT FLEXIBLE HOSE (w/o ABS)
13.INSTALL FRONT SPEED SENSOR WIRE (w/ ABS)
Install the front speed sensor wire and front flexible hose to the body and front shock absorber assembly with the 2 bolts.
Do not twist the front speed sensor wire and front flexible hose when installing them.
Install the front speed sensor harness bracket first and then the front flexible hose bracket.
Engage the 3 clamps.
Engage the 2 clamps to the body.
Connect the front speed sensor connector.
53876A
14.INSTALL FRONT FENDER LINER (w/ ABS)
Install the front fender liner to the body with the 7 clips, 3 screws and 4 new grommets.
| *1 | Pin Hold Clip |
| *a | Correct |
| *b | Incorrect |
Install the pin hold clip as shown in the illustration.
Install the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.
15.INSTALL FRONT WHEEL
16.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
17.CHECK FOR SPEED SENSOR SIGNAL