Home › Drivetrain › U441E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE › 2013.08–2016.10
RM30M0E _52 Drivetrain _017088 U441E AUTOMATIC TRANSMISSION / TRANSAXLE _0090621 TRANSMISSION WIRE A

U441E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSTALLATION  


PROCEDURE

Hide 82125J 1.INSTALL TRANSMISSION WIRE

a.

Apply a light coat of Toyota Genuine ATF Type T-IV to a new O-ring and install it to the transmission wire.

NOTICE:

Do not twist the O-ring.



b.
C203903

Pass the transmission wire through the automatic transaxle case sub-assembly.


c.

Install the transmission wire with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

Make sure that the O-ring is not damaged or does not jump out of position during installation.



d.

Connect the connector to the transmission wire.


Hide 35410 2.INSTALL TRANSMISSION VALVE BODY ASSEMBLY

Hide 74410 3.INSTALL BATTERY CARRIER ASSEMBLY