In some cases, wireless door lock control functions are normal but the hazard warning light answer-back function does not operate. In such cases, hazard warning light signal outputs from the body computer may be malfunctioning.
Check the wireless door lock control function using the door control transmitter assembly.
| Result | Proceed to |
|---|---|
| Wireless door lock/unlock operates properly. | A |
| Wireless door lock/unlock does not operate properly. | B |
A
B
for LHD
Remove the front door lock assembly LH.
Click hereVehicle Interior>DOOR LOCK>FRONT DOOR LOCK(for TMT Made)>REMOVAL
Inspect the front door lock assembly LH.
Click hereVehicle Interior>DOOR LOCK>FRONT DOOR LOCK(for TMT Made)>INSPECTION
for RHD
Remove the front door lock assembly RH.
Click hereVehicle Interior>DOOR LOCK>FRONT DOOR LOCK(for TMT Made)>REMOVAL
Inspect the front door lock assembly RH.
Click hereVehicle Interior>DOOR LOCK>FRONT DOOR LOCK(for TMT Made)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for LHD
Disconnect the H3 front door lock assembly LH connector.
for RHD
Disconnect the G2 front door lock assembly RH connector.
Disconnect the F52 body computer connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H3-8 (LSSR) - F52-15 (LSWD) | Always | Below 1 Ω |
| H3-7 (E) - Body ground | Always | Below 1 Ω |
| H3-8 (LSSR) or F52-15 (LSWD) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G2-7 (LSSR) - F52-15 (LSWD) | Always | Below 1 Ω |
| G2-8 (E) - Body ground | Always | Below 1 Ω |
| G2-7 (LSSR) or F52-15 (LSWD) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the hazard warning light blinks when the hazard warning signal switch is pressed.
Hazard warning light signal is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F39 combination meter assembly connector.
Disconnect the F52 body computer connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F39-3 (HAZ) - F52-6 (HAZ) | Always | Below 1 Ω |
| F39-3 (HAZ) or F52-6 (HAZ) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG