Make sure to release the vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
47201
1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
44772
2.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE (for Automatic Transaxle)
Loosen the 2 hose clips and disconnect the 2 check valve to connector tube hoses from the 2 brake vacuum check valve assemblies.
44772
3.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE (for Manual Transaxle)
Loosen the hose clip and disconnect the check valve to connector tube hose from the brake vacuum check valve assembly.
58910C
4.REMOVE REAR CONSOLE BOX ASSEMBLY
57533B
5.REMOVE FRONT FLOOR CENTER BRACE
17410
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY
51441C
7.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
51451A
8.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
51405A
9.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
12305
10.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
84340
11.REMOVE STOP LIGHT SWITCH ASSEMBLY
12.SEPARATE WIRE HARNESS
47101A
13.REMOVE BRAKE PEDAL RETURN SPRING
47264D
14.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
| *1 | Brake Master Cylinder Push Rod Clevis |
| *2 | Clevis Lock Nut |
Loosen the clevis lock nut of the brake master cylinder push rod clevis.
Remove the clip and push rod pin to separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.
Remove the brake master cylinder push rod clevis and the clevis lock nut from the brake booster assembly.
44610
15.REMOVE BRAKE BOOSTER ASSEMBLY
Disengage the brake tube clamp to separate the brake tubes from the body.
Remove the 4 nuts to separate the brake booster assembly from the body.
Rotate the brake booster assembly as shown in the illustration and remove it.
Do not damage the brake tubes.
Remove the brake booster gasket from the brake booster assembly.