Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for RHD) › 2014.03–2016.04
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092765 BRAKE BOOSTER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.


PROCEDURE

Hide 47201 1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 44772 2.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE (for Automatic Transaxle)

C282221

a.

Loosen the 2 hose clips and disconnect the 2 check valve to connector tube hoses from the 2 brake vacuum check valve assemblies.


Hide 44772 3.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE (for Manual Transaxle)

C282220

a.

Loosen the hose clip and disconnect the check valve to connector tube hose from the brake vacuum check valve assembly.


Hide 58910C 4.REMOVE REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)

Hide 58910C 5.REMOVE REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)

Hide 57533B 6.REMOVE FRONT FLOOR CENTER BRACE

Hide 17410 7.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 51441C 8.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)

Hide 51451A 9.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 51405A 10.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 12305 11.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

Hide 84340 12.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 13.SEPARATE WIRE HARNESS

Hide 47101A 14.REMOVE BRAKE PEDAL RETURN SPRING

Hide 47264D 15.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.
C282222C01
2.531,1.042 2.594,0.823 false 3.031,0.948 2.917,0.729 false 2.469,1.052 2.781,1.208 0.313,0.156 10 false *1 3,0.969 3.313,1.125 0.313,0.156 10 false *2
*1 Brake Master Cylinder Push Rod Clevis
*2 Clevis Lock Nut


Loosen the clevis lock nut of the brake master cylinder push rod clevis.


b.

Remove the clip and push rod pin to separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.


c.

Remove the brake master cylinder push rod clevis and the clevis lock nut from the brake booster assembly.


Hide 44610 16.REMOVE BRAKE BOOSTER ASSEMBLY

a.
C282223

Disengage the brake tube clamp to separate the brake tubes from the body.


b.
C282224

Remove the 4 nuts to separate the brake booster assembly from the body.


c.
C282225

Rotate the brake booster assembly as shown in the illustration and remove it.

NOTICE:

Do not damage the brake tubes.



d.

Remove the brake booster gasket from the brake booster assembly.