Use the same procedure for the LH side (No. 3 parking brake cable assembly) and RH side (No. 2 parking brake cable assembly).
The following procedure is for the LH side (No. 3 parking brake cable assembly).
58910C
1.REMOVE REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
58910C
2.REMOVE REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)
46430
3.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
| *1 | Lock Nut |
Loosen the lock nut.
If the lock nut has been removed from the rod, replace the lock nut with a new one.
Disengage the claw and 2 guides to remove the parking brake cable end stopper from the parking brake equalizer.
| *1 | Parking Brake Equalizer |
| *2 | No. 2 Parking Brake Cable Assembly |
| *3 | No. 3 Parking Brake Cable Assembly |
Disconnect the No. 3 parking brake cable assembly from the parking brake equalizer.
57533B
4.REMOVE FRONT FLOOR CENTER BRACE (for RH Side)
17410
5.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for RH Side)
58156
6.REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR (for RH Side)
77641A
7.REMOVE NO. 1 FUEL TANK PROTECTOR (for RH Side)
8.REMOVE REAR WHEEL (for Rear Drum Brake)
42403
9.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Rear Drum Brake)
10.REMOVE REAR BRAKE STRUT KIT (for Rear Drum Brake)
89516D
11.SEPARATE SKID CONTROL SENSOR WIRE (w/ ABS)
Remove the nut to separate the skid control sensor wire from the rear axle beam assembly.
46430
12.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Rear Drum Brake)
Remove the bolt to disconnect the No. 3 parking brake cable assembly from the backing plate.
Disengage clamp to remove the parking brake cable clamp.
| *1 | Parking Brake Cable Clamp | *2 | No. 3 Parking Brake Cable Assembly |
Remove the No. 3 parking brake cable assembly from the parking brake cable clamp.
Remove the 3 bolts to separate the No. 3 parking brake cable assembly from the body.
Remove the nut and No. 3 parking brake cable assembly from the rear axle beam assembly.
46430
13.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Rear Disc Brake)
Disconnect the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.
| *1 | No. 3 Parking Brake Cable Assembly |
| *a | Clip |
Insert a 14 mm offset wrench at the base of the No. 3 parking brake cable assembly as shown in the illustration to disengage the clip, and separate the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.
Disengage clamp to remove the parking brake cable clamp.
| *1 | Parking Brake Cable Clamp | *2 | No. 3 Parking Brake Cable Assembly |
Remove the No. 3 parking brake cable assembly from the parking brake cable clamp.
Remove the 3 bolts to separate the No. 3 parking brake cable assembly from the body.
Remove the nut and No. 3 parking brake cable assembly from the rear axle beam assembly.