Home › Vehicle Exterior › DOOR / HATCH › HOOD › 2014.03–2017.10
RM30M0E _59 Vehicle Exterior _017122 DOOR / HATCH _0087453 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B277160C06
0.688,0.281 1,0.479 0.313,0.198 10 false *a 2.552,0.281 2.865,0.479 0.313,0.198 10 false *b
*a Centering Bolt
*b Standard Bolt


HINT:
·

Centering bolts are used to mount the hood hinge and the hood lock. The hood and the hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

Specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 53301 1.INSPECT HOOD SUB-ASSEMBLY (for Sedan)

Hide 53301 2.INSPECT HOOD SUB-ASSEMBLY (for Hatchback)

Hide 53141F 3.REMOVE RADIATOR COVER (for Sedan)

Hide 53141F 4.REMOVE RADIATOR COVER (for Hatchback)

Hide 53301 5.ADJUST HOOD SUB-ASSEMBLY

a.
B341587

Adjust hood front/back position and left/right position of hood rear edge.

i.

Loosen the 4 hood side hinge bolts.


ii.

Move the hood to adjust the clearance to within the standard range.



iii.

Tighten the 4 hood side hinge bolts after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.
B341588

Adjust up/down position of hood front left and front right corners.

i.

Turn the 2 cushion rubbers.

HINT:

The cushion rubber can be raised and lowered by turning it.





c.
B347095

Adjust up/down and left/right position of hood front edge.

i.

Loosen the 3 hood lock assembly bolts.


ii.

Adjust the hood lock position so that the striker can enter it smoothly.



iii.

Tighten the 3 hood lock assembly bolts after the adjustment.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)



Hide 53141F 6.INSTALL RADIATOR COVER (for Sedan)

Hide 53141F 7.INSTALL RADIATOR COVER (for Hatchback)