17118
1.REMOVE MANIFOLD STAY
25051
2.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
23814B
3.REMOVE FUEL DELIVERY PIPE
23891
4.REMOVE FUEL DELIVERY SPACER
5.REMOVE FUEL INJECTOR ASSEMBLY
12261
6.REMOVE VENTILATION HOSE
Disengage the 2 clamps to disconnect the ventilation hose from the hose clamp.
Slide the 2 hose clips and remove the ventilation hose from the cylinder head cover sub-assembly and intake manifold.
16267
7.DISCONNECT NO. 3 WATER BY-PASS HOSE
Slide the hose clip and disconnect the No. 3 water by-pass hose from the throttle body with motor assembly.
16264
8.DISCONNECT NO. 2 WATER BY-PASS HOSE
Slide the hose clip and disconnect the No. 2 water by-pass hose from the cylinder head sub-assembly.
9.REMOVE INTAKE MANIFOLD WITH THROTTLE BODY WITH MOTOR ASSEMBLY
Remove the 3 bolts, 2 nuts and intake manifold with throttle body with motor assembly from the cylinder head sub-assembly.
Remove the No. 1 intake manifold to head gasket from the intake manifold.
19500D
10.REMOVE NO. 1 IGNITION COIL
11.REMOVE NO. 2 VENTILATION HOSE
Slide the hose clip and remove the No. 2 ventilation hose from the cylinder head cover sub-assembly.
16268
12.REMOVE NO. 1 WATER BY-PASS PIPE
Disengage the clamp to disconnect the water by-pass hose from the hose clamp.
Remove the bolt to separate the No. 1 water by-pass pipe from the cylinder block sub-assembly.
Slide the hose clip, disconnect the No. 1 water by-pass hose to remove the No. 1 water by-pass pipe from the water inlet with thermostat sub-assembly.
16620
13.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Remove the 2 bolts and V-ribbed belt tensioner assembly from the timing chain cover assembly.
14.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and wire harness clamp bracket from the cylinder head cover sub-assembly.
Remove the 2 bolts and 2 wire harness clamp brackets from the cylinder head sub-assembly.
Remove the bolt and wire harness clamp bracket from the cylinder block sub-assembly.