1.INSTALL ENGINE STAND
for Manual Transaxle: Click hereEngine / Hybrid System>2NR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>REMOVAL
for CVT: Click hereEngine / Hybrid System>2NR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for CVT)>REMOVAL
2.REMOVE ENGINE HANGER
for Manual Transaxle: Click hereEngine / Hybrid System>2NR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>INSTALLATION
for CVT: Click hereEngine / Hybrid System>2NR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for CVT)>INSTALLATION
19500D
3.REMOVE NO. 1 IGNITION COIL
12261
4.REMOVE VENTILATION HOSE
12262
5.REMOVE NO. 2 VENTILATION HOSE
17168
6.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
16268
7.DISCONNECT NO. 1 WATER BY-PASS PIPE
16620
8.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
11101W
9.REMOVE CAMSHAFT POSITION SENSOR
11201
10.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
16321
11.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
16326
12.REMOVE NO. 2 WATER INLET HOUSING GASKET
11301K
13.REMOVE CRANKSHAFT POSITION SENSOR
13471
14.REMOVE CRANKSHAFT PULLEY
11310
15.REMOVE TIMING CHAIN COVER ASSEMBLY
Remove the 3 bolts and engine mounting bracket RH from the timing chain cover assembly.
| *1 | Seal Washer |
Remove the 24 bolts and seal washer from the camshaft housing sub-assembly, cylinder head sub-assembly, cylinder block sub-assembly and oil pan sub-assembly.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the timing chain cover assembly by prying between the timing chain cover assembly, cylinder head sub-assembly, cylinder block sub-assembly and oil pan sub-assembly.
Be careful not to damage the contact surfaces of the timing chain cover assembly, cylinder head sub-assembly, cylinder block sub-assembly and oil pan sub-assembly.
Remove the 3 oil pump O-rings from the oil pan sub-assembly.
16.REMOVE PLUG
Using an 8 mm socket hexagon wrench, remove the plug from the timing chain cover assembly.
11302A
17.REMOVE TIMING CHAIN COVER OIL SEAL
| *a | Protective Tape |
| *b | Wooden Block |
Using a screwdriver with its tip wrapped in protective tape and wooden block, remove the timing chain cover oil seal from the timing chain cover assembly.