Home › Engine / Hybrid System › 1NR-FE FUEL › FUEL SYSTEM › from 2016.07
RM30M0E _51 Engine / Hybrid System _053554 1NR-FE FUEL _0259934 FUEL SYSTEM G

1NR-FE FUEL  FUEL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK

a.

Check fuel pump operation.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.

NOTICE:

Do not start the engine.



iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump /Speed.

Powertrain > Engine and ECT > Active Test
Tester Display
Control the Fuel Pump / Speed
50004 234 5

v.

Check for pressure in the fuel inlet tube from the fuel line. Check that sounds of fuel flowing from the fuel tank can be heard. If no sounds can be heard, check the driver side junction block assembly, fuel pump, ECM and wiring connectors.



b.

Inspect for fuel leaks.

i.

Check for fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts if necessary.



c.

Turn the ignition switch off.


d.

Disconnect the GTS from the DLC3.


Hide 2.CHECK FUEL PRESSURE

a.

Discharge the fuel system pressure.

Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL SYSTEM>PRECAUTION


b.

Check the voltage.

i.

Measure the battery voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
Positive (+) terminal - Negative (-) terminal Ignition switch off 11 to 14 V




c.

Disconnect the cable from the negative (-) battery terminal.

·

for Hatchback

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION





e.

Remove the EFI fuel pipe clamp.

Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL INJECTOR>REMOVAL


f.

Disconnect the fuel tube sub-assembly.

Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL INJECTOR>REMOVAL


g.

Install SST (pressure gauge) using other SST as shown in the illustration.

A341224C01
6.344,1.125 6.615,1.125 false 5.813,2.76 6.667,2.76 true 3.073,0.656 3.344,0.656 false 1.615,2.823 1.76,2.625 false 2.656,3.094 2.656,2.792 false 2.229,3.323 2.229,3.021 false 1.667,3.427 1.448,3.344 false 1.031,0.479 0.802,0.479 false 1.24,0.688 1.01,0.688 false 0.938,1.26 0.708,1.26 false 1.552,0.75 1.396,1.021 false 1.719,0.656 1.656,0.979 false 0.99,1.177 1.302,1.333 0.313,0.156 10 false *1 6.708,2.698 7,2.875 0.292,0.177 10 true *2 0.604,0.396 0.917,0.552 0.313,0.156 10 false *a 0.823,0.625 1.135,0.781 0.313,0.156 10 false *b 1.583,1 1.896,1.156 0.313,0.156 10 false *d 2.177,3.344 2.49,3.5 0.313,0.156 10 false *e 2.594,3.146 2.885,3.323 0.292,0.177 10 false *2 1.281,1.021 1.594,1.177 0.313,0.156 10 false *a 1.813,2.521 2.063,2.729 0.25,0.208 10 false *a 3.396,0.594 3.708,0.75 0.313,0.156 10 false *c 1.698,3.323 2.01,3.479 0.313,0.156 10 false *d 6.688,1.042 7.083,1.24 0.396,0.198 10 false SST
*1 Fuel Tube Sub-assembly *2 Fuel Delivery Pipe
*a SST (Hose Band) *b SST (T-joint)
*c SST (Pressure Gauge) *d SST (Hose)
*e SST (Fuel Tube Connector) - -


SST
09268-45101  (09268-41250, 09268-41260, 09268-41280, 09268-41500, 09268-41700, 95336-08070)


h.

Clean up any spilled gasoline.


i.

Connect the cable to the negative (-) battery terminal.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

·

for Hatchback

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION




j.

Connect the GTS to the DLC3.


k.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

Powertrain > Engine and ECT > Active Test
Tester Display
Control the Fuel Pump / Speed
50004 234 5

l.

Measure the fuel pressure.

Standard:

304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44.1 to 49.7 psi)


·

If the fuel pressure is greater than the standard value, replace the fuel pressure regulator assembly.

·

If the fuel pressure is less than the standard value, check the fuel hoses and connections, fuel pump, fuel pump filter and fuel pressure regulator assembly.



m.

Disconnect the GTS from the DLC3.


n.

Start the engine.


o.

Measure the fuel pressure at idle.

Standard:

304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44.1 to 49.7 psi)



p.

Stop the engine.


q.

Check that the fuel pressure remains as specified for 5 minutes after the engine stops.

Standard:

147 kPa (1.5 kgf/cm2, 21 psi) or more


If the fuel pressure is not as specified, check the fuel pump, fuel pressure regulator assembly and fuel injector assembly.


r.

After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST to prevent gasoline from spraying.


s.

Connect the fuel tube sub-assembly.

Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL INJECTOR>INSTALLATION


t.

Install the EFI fuel pipe clamp.

Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL INJECTOR>INSTALLATION




w.

Inspect for fuel leak.