Make sure to release the vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
47201
1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
44772
2.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE (for CVT)
Loosen the 2 hose clips and disconnect the 2 check valve to connector tube hoses from the 2 brake vacuum check valve assemblies.
44772
3.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE (for Manual Transaxle)
Loosen the hose clip and disconnect the check valve to connector tube hose from the brake vacuum check valve assembly.
57533B
4.REMOVE FRONT FLOOR CENTER BRACE
17410
5.REMOVE FRONT EXHAUST PIPE ASSEMBLY
for Sedan:
Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL TANK(for TMT Made)>REMOVAL
for Hatchback:
Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL TANK(for TMT Made)>REMOVAL
51441C
6.REMOVE ENGINE UNDER COVER RH
12305
7.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
Place a wooden block on a jack underneath the engine assembly.
Remove the 4 bolts, 2 nuts and the engine mounting insulator sub-assembly RH from the timing chain cover assembly and vehicle.
84340
8.REMOVE STOP LIGHT SWITCH ASSEMBLY
9.SEPARATE WIRE HARNESS
47101A
10.REMOVE BRAKE PEDAL RETURN SPRING
47264D
11.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
| *1 | Brake Master Cylinder Push Rod Clevis |
| *2 | Clevis Lock Nut |
Loosen the clevis lock nut of the brake master cylinder push rod clevis.
Remove the clip and push rod pin to separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.
Remove the brake master cylinder push rod clevis and the clevis lock nut from the brake booster assembly.
44610
12.REMOVE BRAKE BOOSTER ASSEMBLY
for 1NR-FE, 2NR-FE:
Disconnect the connector.
Disengage the brake tube clamp to separate the brake tubes from the body.
Remove the 4 nuts to separate the brake booster assembly from the body.
Rotate the brake booster assembly as shown in the illustration and remove it.
Do not damage the brake tubes.
Remove the brake booster gasket from the brake booster assembly.