1.INSTALL ROOF HEADLINING ASSEMBLY
Put the roof headlining assembly into the vehicle through the rear passenger side door.
Do not damage the roof headlining assembly or body interior.
Install the roof headlining assembly with the 4 clips.
for front pillar RH side:
Install the 2 clamps.
Engage the guide.
Install the bolt.
Connect the connector.
for front pillar LH side:
Install the 2 clamps.
Connect the connector.
for rear pillar RH side:
Install the clamp.
Connect the connector.
74348C
2.INSTALL VISOR HOLDER LH
Engage the 2 claws.
Push in the visor holder LH as shown in the illustration.
74348B
3.INSTALL VISOR HOLDER RH
Use the same procedure as for the LH side.
74320
4.INSTALL VISOR ASSEMBLY LH
Install the visor assembly LH with the 2 screws.
Engage the guide.
74310
5.INSTALL VISOR ASSEMBLY RH
Use the same procedure as for the LH side.
74610A
6.INSTALL ASSIST GRIP SUB-ASSEMBLY
Use the same procedure to install all assist grip sub-assemblies.
Install the 2 clips and 2 assist grip covers to the assist grip as shown in the illustration.
Engage the 2 clips and install the assist grip sub-assembly.
63339A
7.INSTALL ROOF HEADLINING SERVICE HOLE COVER (w/ Cover)
Use the same procedure to install all roof headlining service hole covers.
Install the 2 roof headlining service hole covers.
81260A
8.INSTALL MAP LIGHT ASSEMBLY
62472A
9.INSTALL ROOF SIDE INNER GARNISH LH
Engage the guide.
Engage the 4 clips and install the roof side inner garnish LH.
62471A
10.INSTALL ROOF SIDE INNER GARNISH RH
Use the same procedure as for the LH side.
62552F
11.INSTALL REAR SEAT SIDE GARNISH LH
for Separate Seat Type:
Engage the 2 guides and the 2 claws and the clip and install the rear seat side garnish LH.
Install the clip.
for Fixed Seat Type:
Engage the 2 guides and the 2 claws and the clip and install the rear seat side garnish LH.
62551F
12.INSTALL REAR SEAT SIDE GARNISH RH
Use the same procedure as for the LH side.
73370
13.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
73360
14.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62412B
15.INSTALL CENTER PILLAR UPPER GARNISH LH
Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar upper garnish LH.
Engage the clip and install the center pillar upper garnish LH.
Install the 2 screws.
62411B
16.INSTALL CENTER PILLAR UPPER GARNISH RH
Use the same procedure as for the LH side.
62414A
17.INSTALL CENTER PILLAR LOWER GARNISH LH
Engage the 2 claws and the 2 clips and the 2 guides and install the center pillar lower garnish LH.
62413A
18.INSTALL CENTER PILLAR LOWER GARNISH RH
Use the same procedure as for the LH side.
73220
19.CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
73210
20.CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62332A
21.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
| *a | Paint Mark |
| *b | Flange Position |
Align the paint mark on the rear door opening trim weatherstrip LH with the flange position on the vehicle body and install the rear door opening trim weatherstrip LH.
| Area | Color |
|---|---|
| LH Side | Red |
| RH Side | Green |
After installation, check that the corners fit correctly.
62331A
22.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
62212
23.INSTALL FRONT PILLAR GARNISH LH
except 6 speakers:
Engage the 2 guides and the 2 clips and install the front pillar garnish LH.
for 6 speakers:
Connect the connector.
Engage the 2 guides and the 2 clips and install the front pillar garnish LH.
62211
24.INSTALL FRONT PILLAR GARNISH RH
Use the same procedure as for the LH side.
62312B
25.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
| *a | Paint Mark |
| *b | Flange Position |
Align the paint mark on the front door opening trim weatherstrip LH with the flange position on the vehicle body and install the front door opening trim weatherstrip LH.
| Area | Color |
|---|---|
| LH Side | Pink |
| RH Side | Blue |
After installation, check that the corners fit correctly.
62311B
26.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
62112
27.INSTALL COWL SIDE TRIM BOARD LH
Engage the 2 clips and the guide and install the cowl side trim board LH.
Install the clip.
62111C
28.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side.
29.INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)
30.INSTALL REAR SEAT ASSEMBLY (for Separate Seat Type)
31.INSTALL FRONT SEAT ASSEMBLY RH