Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB › from 2017.10
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090087 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 47313A 2.SEPARATE FRONT FLEXIBLE HOSE

Hide 3.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 4.REMOVE FRONT DISC

Hide 5.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C282321

Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front speed sensor.



If the looseness exceeds the maximum, replace the front axle hub sub-assembly.


Hide 6.INSPECT FRONT AXLE HUB RUNOUT

a.
C282322

Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.

Maximum runout:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.

·

Keep the magnet of the dial indicator away from the front speed sensor.



If the runout exceeds the maximum, replace the front axle hub sub-assembly.


Hide 43512 7.INSTALL FRONT DISC

Hide 8.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 47313A 9.INSTALL FRONT FLEXIBLE HOSE

Hide 10.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)