Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
53876A
2.REMOVE FRONT FENDER LINER
3.SEPARATE FRONT SPEED SENSOR WIRE
43502H
4.REMOVE FRONT AXLE SHAFT NUT
5.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
43512
6.REMOVE FRONT DISC
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
48819A
7.SEPARATE FRONT STABILIZER BOLT (w/o Side Rail Reinforcement)
48810
8.SEPARATE FRONT STABILIZER LINK ASSEMBLY (w/ Side Rail Reinforcement)
45047
9.SEPARATE TIE ROD END SUB-ASSEMBLY
Remove the cotter pin and castle nut.
Install SST to the threaded section of the tie rod end sub-assembly.
Make sure the upper ends of the threaded section of the tie rod end sub-assembly and SST are aligned.
Using SST, separate the tie rod end sub-assembly from the steering knuckle.
| *a | Center Nut | *b | String |
| *c | Molybdenum Grease Application Area | *d | Place the wrench here |
| *e | Turn | - | - |
Apply molybdenum grease to the bolt threads and the tip of SST.
Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
Install SST so that A and B are parallel.
Be sure to place the wrench on the part indicated in the illustration.
Do not damage the ball joint dust cover.
Do not damage the front disc brake dust cover.
48069
10.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Remove the clip and castle nut.
Install SST to the threaded section of the lower ball joint.
Make sure the upper ends of the threaded section of the lower ball joint and SST are aligned.
Using SST, separate the front lower No. 1 suspension arm sub-assembly from the steering knuckle.
| *a | Center Nut | *b | String |
| *c | Molybdenum Grease Application Area | *d | Place the wrench here |
| *e | Turn | - | - |
Apply molybdenum grease to the bolt threads and the tip of SST.
Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
Install SST so that A and B are parallel.
Be sure to place the wrench on the part indicated in the illustration.
Do not damage the lower ball joint dust cover.
Do not damage the drive shaft outboard joint boots.
Do not damage the front disc brake dust cover.
11.REMOVE FRONT AXLE ASSEMBLY
| *a | Matchmark |
Put matchmarks on the front drive shaft assembly and front axle hub sub-assembly.
Using a plastic hammer, tap the end of the front drive shaft assembly and separate the fitting between the front drive shaft assembly and front axle assembly.
Be careful not to damage the thread portion of the front drive shaft assembly.
If it is difficult to separate the front drive shaft assembly from the front axle assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.
Remove the 2 nuts, 2 bolts and front axle assembly from the front shock absorber assembly.
Make sure not to deform the front disc brake dust cover.
Hang the front drive shaft assembly with wire or similar.
Keep the bolt from rotating while turning the nut.
43502C
12.REMOVE FRONT AXLE HUB SUB-ASSEMBLY
Hold the steering knuckle in a vise between aluminum plates.
When using a vise, do not overtighten it.
Remove the 3 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.
Do not place the front speed sensor side so that it is facing downward, and do not allow the front speed sensor side to become damaged or contact foreign matter.
Do not drop the front axle hub sub-assembly.
The front axle hub sub-assembly is a component of the front speed sensor.