Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY(for TMMIN Made) › 2017.10–2018.01
RM30M0E _55 Steering _017104 STEERING COLUMN _0333482 STEERING COLUMN ASSEMBLY(for TMMIN Made) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for TMMIN Made)  INSTALLATION  


PROCEDURE

Hide 45879A 1.INSTALL BREAK AWAY CAPSULE

a.

Install 2 new break away capsules to the steering column assembly.


Hide 2.INSTALL STEERING COLUMN ASSEMBLY

a.

Install the steering column assembly to the instrument panel reinforcement assembly with the bolt and 2 nuts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


b.

Engage the wire harness clamp to install the wire harness to the instrument panel reinforcement assembly.


c.

Connect the 2 connectors to the power steering ECU assembly.


d.

Connect all the connectors and engage all the wire harness clamps to the steering column assembly.


Hide 55106 3.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

Hide 45209 4.INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY

a.
C286515C01
1.781,1.531 2.156,1.448 2.156,1.448 1.771,1.448 true 2.198,1.354 2.427,1.521 0.229,0.167 10 true *a 1.74,0.635 1.896,0.802 0.156,0.167 10 true A 2.01,1.125 2.167,1.292 0.156,0.167 10 true B
*a Matchmark


Align the matchmarks on the steering sliding yoke sub-assembly and steering link assembly.


b.

Install the steering sliding yoke sub-assembly to the steering link assembly.


c.

Install bolt B.

Torque:
35.3 N*m (360 kgf*cm, 26 ft.*lbf)


d.

Tighten bolt A.

Torque:
35.3 N*m (360 kgf*cm, 26 ft.*lbf)


Hide 45259A 5.INSTALL COLUMN HOLE COVER SILENCER SHEET

a.

Install the column hole cover silencer sheet with the 2 clips.


Hide 55432B 6.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL

Hide 55606 7.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 8.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

a.

Using pliers, pinch the clamp and attach the claw to install the combination switch assembly with spiral cable sub-assembly to the steering column assembly.


b.

Connect all the connectors to the combination switch assembly with spiral cable sub-assembly.


Hide 45286B 9.INSTALL UPPER STEERING COLUMN COVER

a.

Engage the claw to install the upper steering column cover.


Hide 45287 10.INSTALL LOWER STEERING COLUMN COVER

a.

Engage the 3 claws to install the lower steering column cover.


b.

Install the 3 screws.


Hide 45289A 11.INSTALL STEERING COLUMN COVER SUPPORT (w/ Smart Entry and Start System)

a.

Engage the 4 claws to install the steering column cover support.


Hide 12.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45100 14.INSTALL STEERING WHEEL ASSEMBLY

Hide 45130 15.INSTALL HORN BUTTON ASSEMBLY

Hide 16. PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT