55106
1.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY
Temporarily install the brake pedal support sub-assembly to the body and instrument panel reinforcement with the 4 nuts and bolt.
Tighten the 4 nuts in the order shown in the illustration.
Tighten the bolt.
47264D
2.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
|
Lithium Soap Base Glycol Grease |
Apply lithium soap base glycol grease to the push rod pin.
Install the brake master cylinder push rod clevis to the brake pedal sub-assembly with the push rod pin and a new clip.
Install the push rod pin from the right side of the vehicle.
47101A
3.INSTALL BRAKE PEDAL RETURN SPRING
Install the brake pedal return spring to the brake pedal support sub-assembly and push rod pin.
4.INSTALL WIRE HARNESS
Engage the wire harness clamp.
84345
5.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
Install a new stop light switch mounting adjuster to the brake pedal support sub-assembly.
84340
6.INSTALL STOP LIGHT SWITCH ASSEMBLY
7.INSPECT AND ADJUST BRAKE PEDAL
45209
8.INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY
for TMT Made:
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for TMT Made)>INSTALLATION
for TMMIN Made:
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for TMMIN Made)>INSTALLATION
45259A
9.INSTALL COLUMN HOLE COVER SILENCER SHEET
for TMT Made:
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for TMT Made)>INSTALLATION
for TMMIN Made:
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for TMMIN Made)>INSTALLATION
55411G
10.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL (for TMMIN Made)
55432B
11.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for TMMIN Made)
55606
12.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for TMMIN Made)
55302A
13.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY (for TMT Made)