Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL(for RHD) › 2017.10–2018.01
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092763 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  INSTALLATION  


PROCEDURE

Hide 55106 1.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.

Temporarily install the brake pedal support sub-assembly to the body and instrument panel reinforcement with the 4 nuts and bolt.


b.
C282213E02
0.563,0.333 0.719,0.531 0.156,0.198 10 false 1 2.198,0.25 2.354,0.448 0.156,0.198 10 false 2 0.677,1.615 0.833,1.813 0.156,0.198 10 false 3 2.313,1.542 2.469,1.74 0.156,0.198 10 false 4

Tighten the 4 nuts in the order shown in the illustration.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


c.

Tighten the bolt.

Torque:
23.6 N*m (241 kgf*cm, 17 ft.*lbf)


Hide 47264D 2.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.
C272700C02
0,0 3.427,0 false
V100145

Lithium Soap Base Glycol Grease


Apply lithium soap base glycol grease to the push rod pin.


b.

Install the brake master cylinder push rod clevis to the brake pedal sub-assembly with the push rod pin and a new clip.

NOTICE:

Install the push rod pin from the left side of the vehicle.



Hide 47101A 3.INSTALL BRAKE PEDAL RETURN SPRING

a.

Install the brake pedal return spring to the brake pedal support sub-assembly and push rod pin.


Hide 4.INSTALL WIRE HARNESS

a.

Connect the accelerator pedal sensor assembly connector.


b.

Engage the 2 wire harness clamps.


Hide 84345 5.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.

Install a new stop light switch mounting adjuster to the brake pedal support sub-assembly.


Hide 84340 6.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 7.INSPECT AND ADJUST BRAKE PEDAL

Hide 55411G 8.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL (for TMMIN Made)

Hide 55432B 9.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for TMMIN Made)

Hide 55606 10.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for TMMIN Made)

Hide 55302A 11.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY (for TMT Made)