17880
1.REMOVE AIR CLEANER HOSE ASSEMBLY
2.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
3.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17701
4.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
28800
5.REMOVE BATTERY
74431
6.REMOVE BATTERY TRAY
74410
7.REMOVE BATTERY CARRIER ASSEMBLY
58910C
8.REMOVE REAR CONSOLE BOX ASSEMBLY (for Integrated Type)
58910C
9.REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Type)
58816D
10.REMOVE NO. 1 FRONT CONSOLE BOX INSERT (for TMT Made)
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL
58817A
11.REMOVE NO. 2 FRONT CONSOLE BOX INSERT (for TMT Made)
58911A
12.REMOVE NO. 1 SIDE BOX PANEL (for TMT Made)
58912C
13.REMOVE NO. 2 SIDE BOX PANEL (for TMT Made)
58916
14.REMOVE BOX BOTTOM MAT (for TMT Made)
58839A
15.REMOVE CONSOLE BOX HOLE COVER (for TMT Made)
58810J
16.REMOVE CONSOLE BOX ASSEMBLY (for TMT Made)
57533B
17.REMOVE FRONT FLOOR CENTER BRACE (for TMMIN Made)
57533B
18.REMOVE FRONT FLOOR CENTER BRACE (for TMT Made)
17410
19.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for TMMIN Made)
17410
20.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for TMT Made)
58151
21.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove the 2 bolts, nut and front No. 1 floor heat insulator from the body.
33820B
22.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
To prevent damage to the transmission control cable assembly and transmission floor shift assembly, disconnect the transmission floor shift assembly side of the transmission control cable assembly before disconnecting the continuously variable transaxle assembly side.
Apply the parking brake and move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.
| *1 | Nut |
|
Rotate approximately 180° |
|
Pull out |
Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the transmission floor shift assembly.
Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.
Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.
Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
Remove the 3 nuts and transmission control cable assembly from the body.