Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SWITCH(for TMT Made) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0334618 WINDOW DEFOGGER SWITCH(for TMT Made) A

WINDOW / GLASS  WINDOW DEFOGGER SWITCH(for TMT Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 55046A 1.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 55045A 2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 55412D 3.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

Hide 55412D 4.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)

Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 73900 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 45287 7.REMOVE LOWER STEERING COLUMN COVER

Hide 55900A 9.REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY

a.
B487205

Disengage the clamp and claw to disconnect the defroster damper control cable sub-assembly.


b.
B487223

Disengage the clamp and claw to disconnect the air mix damper control cable sub-assembly.


c.
B487206

Disengage the 3 claws to disconnect the heater control and accessory assembly.


d.
B487229

Disengage the 2 clamps and disconnect the 2 connectors to remove the heater control and accessory assembly.


Hide 55906A 10.REMOVE DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY

a.
B487208

Disengage the clamp as shown in the illustration.


b.

Disengage the claw to remove the defroster damper control cable sub-assembly.


Hide 55909C 11.REMOVE AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY

a.
B487224

Disengage the clamp as shown in the illustration.


b.

Disengage the claw to remove the air mix damper control cable sub-assembly.