Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for RHD) › from 2017.10
RM30M0E _52 Drivetrain _017089 CLUTCH _0091164 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

Wash off clutch fluid immediately if it comes in contact with any painted surface.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55480D 4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55432B 5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

Hide 73900 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 31434C 8.DISCONNECT CLUTCH RESERVOIR TUBE

a.
C283231

Loosen the hose clip and disconnect the clutch reservoir tube from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.



Hide 31481 9.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C235142

Using a 10 mm union nut wrench, disconnect the clutch master cylinder to flexible hose tube from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.



Hide 31453 10.DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

Hide 31410 11.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

a.
C235127

Remove the 2 nuts and clutch master cylinder assembly from the body.


Hide 31453 12.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.
C125988C02
2.177,0.885 2.594,0.469 false 1.635,1.104 1.115,0.5 false 0.969,0.396 1.281,0.552 0.313,0.156 10 false *1 2.625,0.365 2.938,0.521 0.313,0.156 10 false *2 1.135,1.844 1.292,2.042 0.156,0.198 10 false A
*1 Lock Nut
*2 Clutch Master Cylinder Push Rod Clevis


Measure the dimension A as shown in the illustration before loosening the lock nut.


b.

Loosen the lock nut and remove the clutch master cylinder push rod clevis from the clutch master cylinder assembly.

NOTICE:

When loosening the lock nut, be sure to hold the clutch master cylinder push rod clevis in place by its square portion.



c.

Remove the lock nut from the clutch master cylinder assembly.