Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEELS
51442C
2.REMOVE ENGINE UNDER COVER LH (w/o Metal Type Under Cover)
51441C
3.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
51451A
4.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
51405A
5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
6.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID (for CVT)
Click hereDrivetrain>K312 CVT>OIL PAN>REMOVAL
7.DRAIN MANUAL TRANSAXLE OIL (for Manual Transaxle)
43502H
8.REMOVE FRONT AXLE SHAFT NUT
Using SST and a hammer, release the staked part of the front axle shaft nut.
Loosen the staked part of the nut completely, otherwise the threads of the front drive shaft assembly may be damaged.
Using a 30 mm deep socket wrench, remove the front axle shaft nut.
Keep depressing the brake pedal to prevent the front drive shaft assembly from rotating.
47313A
9.SEPARATE FRONT FLEXIBLE HOSE
Remove the 2 bolts and separate the front flexible hose and front speed sensor wire from the front shock absorber assembly and body.
10.SEPARATE TIE ROD END SUB-ASSEMBLY
11.REMOVE FRONT STABILIZER BOLT (w/o Side Rail Reinforcement)
48810
12.SEPARATE FRONT STABILIZER LINK ASSEMBLY (w/ Side Rail Reinforcement)
48069
13.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
14.SEPARATE FRONT AXLE ASSEMBLY
| *a | Matchmark |
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
Using a plastic hammer, tap the end of the front drive shaft assembly and separate the fitting between the front drive shaft assembly and the front axle assembly.
Be careful not to damage the front drive shaft assembly.
If it is difficult to separate the front drive shaft assembly from the front axle assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.
43498A
15.REMOVE NO. 1 DRIVE SHAFT HEAT INSULATOR (for CVT)
43498A
16.REMOVE NO. 1 DRIVE SHAFT HEAT INSULATOR (for Manual Transaxle)
43420
17.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft assembly LH from the transaxle.
Do not damage the front drive shaft oil seal LH.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly LH.
43410
18.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Using a brass bar and a hammer, remove the front drive shaft assembly RH from the transaxle.
Do not damage the front drive shaft oil seal RH.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly RH.
43420G
19.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING
Using a screwdriver, remove the front drive shaft hole snap ring from the front drive shaft assembly.
20.FIX FRONT AXLE ASSEMBLY
The hub bearing could be damaged if it is subjected to the vehicle's full weight, such as when moving the vehicle with the drive shaft removed. If it is absolutely necessary to place the vehicle's full weight on the hub bearing, first support it with SST.