The combination meter assembly and steering pad switch assembly are connected via direct line. The main display and multi-information display in the combination meter assembly are operated using the switches of the steering pad switch assembly.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Remove the steering pad switch assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEERING PAD SWITCH(for TMT Made)>REMOVAL
Inspect the steering pad switch assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEERING PAD SWITCH(for TMT Made)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE(for TMT Made)>REMOVAL
Inspect the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE(for TMT Made)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F38 combination meter assembly connector.
Disconnect the F143 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F38-25 (MSTI) - F143-11 (-DP) | Always | Below 1 Ω |
| F38-26 (MSM+) - F143-10 (+DP) | Always | Below 1 Ω |
| F143-3 (EAU) - Body ground | Always | Below 1 Ω |
| F38-25 (MSTI) or F143-11 (-DP) - Body ground | Always | 10 kΩ or higher |
| F38-26 (MSM+) or F143-10 (+DP) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG