63310
1.INSTALL ROOF HEADLINING ASSEMBLY
|
Install in this Direction |
Put the roof headlining assembly into the vehicle through the rear door RH.
Do not damage the roof headlining assembly or body interior.
Install the roof headlining assembly with the 2 clips.
for Rear Pillar RH Side:
Engage the 2 clamps to connect the No. 2 antenna cord sub-assembly.
Connect the connector.
74348C
2.INSTALL VISOR HOLDER LH
74348B
3.INSTALL VISOR HOLDER RH
Use the same procedure as for the LH side.
74320
4.INSTALL VISOR ASSEMBLY LH
74310
5.INSTALL VISOR ASSEMBLY RH
Use the same procedure as for the LH side.
74610A
6.INSTALL ASSIST GRIP SUB-ASSEMBLY
63339A
7.INSTALL ROOF HEADLINING SERVICE HOLE COVER (w/o Assist Grip)
Install the 2 roof headlining service hole covers.
81240J
8.INSTALL ROOM LIGHT ASSEMBLY
81260A
9.INSTALL MAP LIGHT ASSEMBLY
62472A
10.INSTALL ROOF SIDE INNER GARNISH LH
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide and 4 clips to install the roof side inner garnish LH as shown in the illustration.
62471A
11.INSTALL ROOF SIDE INNER GARNISH RH
Use the same procedure as for the LH side.
62552F
12.INSTALL REAR SEAT SIDE GARNISH LH
|
Install in this Direction |
Engage the 4 guides, 2 claws and clip to install the rear seat side garnish LH as shown in the illustration.
for Separate Seat Type:
Install the clip.
62551F
13.INSTALL REAR SEAT SIDE GARNISH RH
Use the same procedure as for the LH side.
73370
14.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
73360
15.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62412B
16.INSTALL CENTER PILLAR UPPER GARNISH LH
62411B
17.INSTALL CENTER PILLAR UPPER GARNISH RH
Use the same procedure as for the LH side.
62414A
18.INSTALL CENTER PILLAR LOWER GARNISH LH
62413A
19.INSTALL CENTER PILLAR LOWER GARNISH RH
Use the same procedure as for the LH side.
73220
20.CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
73210
21.CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62332A
22.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
| *a | Paint Mark |
| *b | Flange Position |
Align the paint mark on the rear door opening trim weatherstrip LH with the flange position on the vehicle body and install the rear door opening trim weatherstrip LH.
| Area | Color |
|---|---|
| RH Side | Brown |
| LH Side | White |
After installation, check that the corners fit correctly.
62331A
23.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
67918A
24.INSTALL REAR DOOR SCUFF PLATE LH
67917A
25.INSTALL REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
62212
26.INSTALL FRONT PILLAR GARNISH LH (w/ Curtain Shield Airbag)
62211
27.INSTALL FRONT PILLAR GARNISH RH (w/ Curtain Shield Airbag)
Use the same procedure as for the LH side.
62212
28.INSTALL FRONT PILLAR GARNISH LH (w/o Curtain Shield Airbag)
62211
29.INSTALL FRONT PILLAR GARNISH RH (w/o Curtain Shield Airbag)
Use the same procedure as for the LH side.
62312B
30.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62311B
31.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
62112
32.INSTALL COWL SIDE TRIM BOARD LH
62111C
33.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side.
67914
34.INSTALL FRONT DOOR SCUFF PLATE LH
67913
35.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
36.INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)
37.INSTALL REAR SEAT ASSEMBLY (for Separate Seat Type)
38.INSTALL FRONT SEAT ASSEMBLY RH