Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
55909C
1.INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY
Engage the claw.
| *a | Outer Clamp Case |
Pull out the inner cable from the outer cable, and pass it through the outer clamp case.
Insert the outer cable into the outer clamp case to install the air mix damper control cable sub-assembly as shown in the illustration.
55906A
2.INSTALL DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY
Engage the claw.
| *a | Outer Clamp Case |
Pull out the inner cable from the outer cable, and pass it through the outer clamp case.
Insert the outer cable into the outer clamp case to install the defroster damper control cable sub-assembly as shown in the illustration.
55900A
3.INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY
Connect the 2 connectors and engage the 2 clamps to install the heater control and accessory assembly.
Engage the 3 claws to connect the heater control and accessory assembly.
Engage the claw and clamp to connect the defroster damper control cable sub-assembly as shown in the illustration.
Engage the claw and clamp to connect the air mix damper control cable sub-assembly as shown in the illustration.
87211C
4.INSTALL NO. 4 AIR DUCT
45287
5.INSTALL LOWER STEERING COLUMN COVER
55606
6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
73900
7.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
55412D
8.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)
9.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)
55046A
10.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
55045A
11.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
Use the same procedure as for the LH side.