55106
1.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY
Temporarily install the brake pedal support sub-assembly to the body and instrument panel reinforcement with the 4 nuts and bolt.
Tighten the 4 nuts in the order shown in the illustration.
Tighten the bolt.
47264D
2.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
|
Lithium Soap Base Glycol Grease |
Apply lithium soap base glycol grease to the push rod pin.
Install the brake master cylinder push rod clevis to the brake pedal sub-assembly with the push rod pin and a new clip.
Install the push rod pin from the left side of the vehicle.
47101A
3.INSTALL BRAKE PEDAL RETURN SPRING
Install the brake pedal return spring to the brake pedal support sub-assembly and push rod pin.
4.INSTALL WIRE HARNESS
Connect the accelerator pedal sensor assembly connector.
Engage the 2 wire harness clamps.
84345
5.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
Install a new stop light switch mounting adjuster to the brake pedal support sub-assembly.
84340
6.INSTALL STOP LIGHT SWITCH ASSEMBLY
7.INSPECT AND ADJUST BRAKE PEDAL
55302A
8.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY