1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
17880
3.REMOVE AIR CLEANER HOSE ASSEMBLY
4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
5.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17701
6.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
28800
7.REMOVE BATTERY
74431
8.REMOVE BATTERY TRAY
74410
9.REMOVE BATTERY CARRIER ASSEMBLY
58910C
10.REMOVE REAR CONSOLE BOX ASSEMBLY
58816D
11.REMOVE NO. 1 FRONT CONSOLE BOX INSERT
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL
58817A
12.REMOVE NO. 2 FRONT CONSOLE BOX INSERT
58911A
13.REMOVE NO. 1 BOX SIDE PANEL
58912C
14.REMOVE NO. 2 BOX SIDE PANEL
58916
15.REMOVE BOX BOTTOM MAT
58839A
16.REMOVE CONSOLE BOX HOLE COVER
58810J
17.REMOVE CONSOLE BOX ASSEMBLY
33820B
18.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
To prevent damage to the transmission control cable assembly and transmission floor shift assembly, disconnect the transmission floor shift assembly side of the transmission control cable assembly before disconnecting the continuously variable transaxle assembly side.
Apply the parking brake and move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.
Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.
Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
84540
19.REMOVE PARK/NEUTRAL POSITION SWITCH
Disconnect the park/neutral position switch connector.
Remove the nut, washer and transmission control shaft lever from the continuously variable transaxle assembly.
Using a screwdriver, pry off the tabs of the lock plate.
Remove the lock nut and lock plate from the park/neutral position switch.
Remove the 2 bolts and pull out the park/neutral position switch from the continuously variable transaxle assembly.