33820B
1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
To prevent damage to the transmission control cable assembly and transmission floor shift assembly, connect the continuously variable transaxle assembly side of the transmission control cable assembly before connecting the transmission floor shift assembly side.
Install the transmission control cable assembly to the body with the 3 nuts.
Rotate the transmission control shaft lever clockwise until it stops, and then from that position rotate it counterclockwise by 2 notches to set it to the N position.
Install the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
Make sure that the paint mark on the transmission control cable assembly is aligned with the slit in the No. 1 transmission control cable bracket before installing the clip.
Connect the transmission control cable assembly to the transmission control shaft lever with the nut.
| *1 | Nut |
| *2 | Lock |
|
Rotate approximately 180° |
|
Push in |
Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.
Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.
| *1 | Lock |
| *a | Protrusion |
|
Push in |
Install the transmission control cable assembly to the transmission floor shift assembly.
Install the transmission control cable assembly with the protrusion facing upwards.
After installation, make sure that the lock is projecting from A as shown in the illustration.
Make sure that the transmission control cable assembly is securely locked.
Confirm that the shift lever is in N, and then connect the end of the transmission control cable assembly to the transmission floor shift assembly.
Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.
Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.
2.ADJUST SHIFT LEVER POSITION
58151
3.INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
Install the front No. 1 floor heat insulator to the body with the 2 bolts and nut.
17410
4.INSTALL FRONT EXHAUST PIPE ASSEMBLY
for TMMIN Made:
Click hereEngine / Hybrid System>2NR-FE FUEL>FUEL TANK(for TMMIN Made)>INSTALLATION
for TMT Made:
Click hereEngine / Hybrid System>2NR-FE FUEL>FUEL TANK(for TMT Made)>INSTALLATION
57533B
5.INSTALL FRONT FLOOR CENTER BRACE
58810J
6.INSTALL CONSOLE BOX ASSEMBLY
58839A
7.INSTALL CONSOLE BOX HOLE COVER
58916
8.INSTALL BOX BOTTOM MAT
58912C
9.INSTALL NO. 2 BOX SIDE PANEL
58911A
10.INSTALL NO. 1 BOX SIDE PANEL
58817A
11.INSTALL NO. 2 FRONT CONSOLE BOX INSERT
58816D
12.INSTALL NO. 1 FRONT CONSOLE BOX INSERT
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>INSTALLATION
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>INSTALLATION
58910C
13.INSTALL REAR CONSOLE BOX ASSEMBLY
74410
14.INSTALL BATTERY CARRIER ASSEMBLY
74431
15.INSTALL BATTERY TRAY
28800
16.INSTALL BATTERY
17701
17.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
18.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
19.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
17880
20.INSTALL AIR CLEANER HOSE ASSEMBLY
21.INSPECT FOR EXHAUST GAS LEAK
22.INSPECT SHIFT LEVER POSITION