Home › Engine / Hybrid System › 1NR-FE COOLING › COOLING FAN MOTOR › from 2018.01
RM30M0E _51 Engine / Hybrid System _053564 1NR-FE COOLING _0259960 COOLING FAN MOTOR A

1NR-FE COOLING  COOLING FAN MOTOR  INSTALLATION  


PROCEDURE

Hide 16363 1.INSTALL COOLING FAN MOTOR

a.

Install the cooling fan motor to the fan shroud with the 3 screws.

Torque:
3.9 N*m (40 kgf*cm, 35 in.*lbf)


Hide 16361 2.INSTALL FAN

a.

Install the fan to the cooling fan motor with the nut.

Torque:
6.3 N*m (64 kgf*cm, 56 in.*lbf)


Hide 16711 3.INSTALL FAN SHROUD

a.
A381287

Engage the 3 guides and 2 claws to install the fan shroud to the radiator assembly.

NOTICE:

Do not apply any excessive force to the radiator assembly when installing the fan shroud.



b.

Engage the 3 clamps to connect the wire harness to the fan shroud.


c.

Connect the cooling fan motor connector.


Hide 17751 4.INSTALL NO. 1 AIR CLEANER INLET

a.

Engage the 3 claws to install the No. 1 air cleaner inlet to the air cleaner case sub-assembly.


Hide 5.INSTALL WIRE HARNESS CLAMP BRACKET

a.

Install the wire harness clamp bracket to the cylinder head sub-assembly with the bolt.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


b.

Engage the clamp to connect the wire harness to the wire harness clamp bracket.


c.

Engage the 2 clamps to connect the air fuel ratio sensor wire to the wire harness clamp bracket.


d.

Connect the air fuel ratio sensor connector.


Hide 16571C 6.CONNECT NO. 1 RADIATOR HOSE

Hide 7.CONNECT RADIATOR RESERVOIR TANK HOSE