The combination meter assembly and steering pad switch assembly are connected via direct line. The multi-information display in the combination meter assembly are operated using the switches of the steering pad switch assembly.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
OK
NG
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H60 spiral cable sub-assembly connector.
Disconnect the H6 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H60-10 (+DP2) - H6-15 (MSTI) | Always | Below 1 Ω |
| H60-11 (+DP) -H6-32 (MSM+) | Always | Below 1 Ω |
| H60-4(EAU) - Body ground | Always | Below 1 Ω |
| H60-10 (+DP2) or H6-15 (MSTI) - Body ground | Always | 10 kΩ or higher |
| H60-11 (+DP) or H6-32 (MSM+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG