89348N
1.REMOVE NO. 1 ULTRASONIC SENSOR CLIP (w/ Parking Support Brake System)
89341K
2.REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ Parking Support Brake System)
89341L
3.REMOVE FRONT CENTER ULTRASONIC SENSOR (w/ Parking Support Brake System)
89347B
4.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ Parking Support Brake System)
88211B
5.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
82113
6.REMOVE NO. 3 ENGINE ROOM WIRE (w/ Wire Harness)
w/ Parking Support Brake System:
Disengage the clamps to remove the No.3 engine room wire.
w/o Parking Support Brake System:
Disengage the clamps to remove the No.3 engine room wire.
75311
7.REMOVE RADIATOR GRILLE (OR FRONT PANEL) EMBLEM
| *a | Heated Part |
| *b | Heat Light |
When removing the radiator grille (or front panel) emblem, heat the front bumper assembly and radiator grille (or front panel) emblem a heat light.
| Item | Temperature |
|---|---|
·
Front Bumper Assembly ·
Radiator Grille (or front panel) Emblem |
20 to 30°C (68 to 86°F) |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front bumper assembly and radiator grille (or front panel) emblem excessively.
| *a | Location Pin |
|
Protective Tape |
Apply protective tape around the radiator grille (or front panel) emblem.
Using a moulding remover D, separate the doublesided tape and disengage the location pins to remove the radiator grille (or front panel) emblem.
Remove the protective tape.
8.REMOVE WIRING HARNESS CONNECTOR (w/o Parking Support Brake System)
Disengage the clamp to remove the wiring harness connector.
52113D
9.REMOVE FRONT BUMPER EXTENSION LH
Disengage the claws to remove the front bumper extension LH.
52112D
10.REMOVE FRONT BUMPER EXTENSION RH
Use the same procedure as for the LH side.
52127C
11.REMOVE FRONT BUMPER HOLE COVER
Disengage the claws.
Disengage the hook to remove the front bumper hole cover.
52129D
12.REMOVE FRONT BUMPER LOWER COVER
Disengage the claws.
Disengage the hook to remove the front bumper lower cover.
53395E
13.REMOVE HOOD TO FRONT END PANEL SEAL
Disengage the clips to remove the hood to front end panel seal.
53155D
14.REMOVE NO. 1 RADIATOR GRILLE SEAL
Remove the 2 screws.
Disengage the claws to remove the No. 1 radiator grille seal.
53101
15.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
Remove the 2 screws and 4 clips.
Disengage the claws to remove the radiator grille sub-assembly.
Remove the 2 nuts.
53112A
16.REMOVE LOWER RADIATOR GRILLE
Remove the 3 screws.
Disengage the claws to remove the lower radiator grille.
53879H
17.REMOVE FRONT FENDER LINER RETAINER
Disengage the claw to remove the front fender liner retainer.
Use the same procedure for the RH side and LH side.
18.REMOVE HEADLIGHT ASSEMBLY LH
for Halogen Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Halogen Headlight)>REMOVAL
for LED Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>REMOVAL
19.REMOVE HEADLIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
52536
20.REMOVE FRONT BUMPER SIDE RETAINER LH
Disengage the claws to remove the front bumper side retainer LH.
52535
21.REMOVE FRONT BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
16681A
22.REMOVE RADIATOR UPPER AIR GUIDE PLATE
Disengage the wire harness clamp.
Disengage the clips to remove the radiator upper air guide plate.
52611
23.REMOVE FRONT BUMPER ENERGY ABSORBER
Disengage the guides to remove the front bumper energy absorber.
88790B
24.SEPARATE THERMISTOR ASSEMBLY
Disengage the clamps to separate the thermistor assembly.
52131A
25.REMOVE FRONT BUMPER REINFORCEMENT
Disengage the wire harness clamps.
Remove the 2 nuts.
Remove the 8 bolts and front bumper reinforcement.
16695A
26.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH
|
Remove in this Direction |
Disengage the claws to remove the front radiator side air guide plate LH as shown in the illustration.
16691A
27.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH
|
Remove in this Direction |
Disengage the claws to remove the front radiator side air guide plate RH as shown in the illustration.
28.REMOVE NO. 2 RADIATOR TO SUPPORT SEAL
for Gasoline Model:
|
Remove in this Direction |
Disengage the claws to remove the No. 2 radiator to support seal as shown in the illustration.
for HV Model:
|
Remove in this Direction |
Disengage the claws to remove the No. 2 radiator to support seal as shown in the illustration.
16595D
29.REMOVE NO. 1 RADIATOR AIR GUIDE LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the claws to remove the No. 1 radiator air guide LH as shown in the illustration.
16561D
30.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the claws to remove the No. 1 radiator to support seal as shown in the illustration.
57014C
31.REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY LH
If reusing the front side member bracket sub-assembly LH:
Put matchmarks on the front side member bracket sub-assembly LH as shown in the illustration.
Disengage the clamp.
Remove the 5 bolts and front side member bracket sub-assembly LH.
57013D
32.REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY RH
If reusing the front side member bracket sub-assembly RH:
Put matchmarks on the front side member bracket sub-assembly RH as shown in the illustration.
Remove the 5 bolts and front side member bracket sub-assembly RH.
51451A
33.REMOVE CENTER ENGINE UNDER COVER
52618
34.REMOVE FRONT BUMPER LOWER ABSORBER
| *a | screw |
| *b | clip |
Remove the clip and 7 screws.
Disengage the claws to remove the front bumper lower absorber.
Remove the 4 grommets.